Micro Irrigation (Drip/Sprinkler) Subsidy Scheme under PMKSY-Per Drop More Crop (Haryana)

What is the micro irrigation subsidy in Haryana?

Micro irrigation subsidy in Haryana is delivered under the Per Drop More Crop component of the Pradhan Mantri Krishi Sinchayee Yojana (PMKSY). According to the national PMKSY portal, this component focuses on water use efficiency at farm level through micro irrigation: drip and sprinkler irrigation systems.

The point most farmers in Haryana get wrong is which department to approach. The DBT Haryana scheme list records Per Drop-More Crop under the Department of Irrigation and Water Resources, not under the Department of Agriculture and Farmers Welfare. Farmers who go to the agriculture office with a drip irrigation query are frequently sent back for that reason. In the field, micro irrigation and command area development work in Haryana is carried out through the state's command area development machinery under that department.

Haryana has a hard reason to push this. Large parts of the state draw irrigation water from falling water tables, and several blocks are notified by the Central Ground Water Authority. Converting flood irrigation to drip or sprinkler is the cheapest way to cut the volume drawn per acre without cutting the cropped area.

What does the scheme cover?

The component supports:

• Drip irrigation systems, the highest water saving, used for orchards, vegetables, cotton and other widely spaced crops.
• Mini-sprinkler and sprinkler systems, used for close-spaced crops, fodder and light soils where flood irrigation loses water to percolation.
• Farm water storage tanks that feed a micro irrigation system, so that a limited canal turn or a low-yield tubewell can be stored and then applied through the system.

Assistance is calculated per hectare against approved cost norms for the system type, spacing and crop, not against whatever the supplier quotes.

A note on rates. The exact subsidy percentage and the per-hectare ceiling are notified by the Department of Irrigation and Water Resources for each financial year and vary by system type and farmer category. Those year-specific figures were not available on an official Haryana page at the time this guide was checked, so they are deliberately not stated here. Get the current rate in writing from the department or the district micro irrigation office before you sign a supplier quotation, it is the single number that determines what you pay.

Who is eligible for micro irrigation subsidy?

You can apply if:

• You are a farmer in Haryana and the land is recorded in your name in the jamabandi or fard.
• You have an assured water source — tubewell, canal outlet or farm pond, serving that land.
• You hold a valid Parivar Pehchan Patra (Family ID).
• You have a DBT-enabled, Aadhaar-linked bank account.
• You will buy the system from a supplier empanelled with the department.

You cannot apply if:

• The land is not in your name. Tenants and lessees without a recorded interest are not eligible in their own right.
• There is no water source on the land. A drip system with nothing to pump is not a fundable project.
• You have already taken subsidy for micro irrigation on the same area within the period the department specifies for repeat assistance.
• You want to buy from a non-empanelled supplier, or to have the subsidy paid against a price rather than the approved cost norms.
• Your bank account is not DBT-enabled, in which case the transfer will fail even after sanction.

What documents are needed?

How to apply for drip or sprinkler subsidy in Haryana

1. Contact the district micro irrigation office of the Department of Irrigation and Water Resources and confirm the current year's targets, subsidy rate and application window before doing anything else.
2. Get your land record and Family ID in order. A mismatch between the jamabandi name and the PPP record is the most common cause of delay in every Haryana farm scheme.
3. Take a quotation from an empanelled supplier for the area you want covered, specifying system type, spacing and crop.
4. File the application with the department along with the land record, Aadhaar, bank details, water source proof and the supplier quotation, and keep the acknowledgement.
5. Allow the field verification; departmental staff measure the area, check the water source and approve the design before installation.
6. Install the system through the empanelled supplier only after the technical sanction is issued.
7. Present the installed system for post-installation inspection, after which the subsidy is released by DBT into your bank account.

Why micro irrigation applications get held up

• Land record mismatch between the jamabandi, the Family ID and the applicant.
• No verified water source, or a source that cannot deliver the pressure the design needs.
• Installation started before technical sanction, which leaves the farmer with a system the department has not approved.
• Non-empanelled supplier, which cannot be regularised afterwards.
• Bank account not DBT-enabled, or a DBT limit too low for the subsidy amount.
• Targets exhausted for the year in that district, in which case the file waits for the next allocation.

Where to get help

Take a stuck file to the district office of the Department of Irrigation and Water Resources, which is the sanctioning department for Per Drop More Crop in Haryana. For general farm-scheme queries the Department of Agriculture and Farmers Welfare toll-free number 1800-180-2117 operates Monday to Friday between 9:00 AM and 5:00 PM and can direct you to the right office.

If you are also planning a solar pump, note that HAREDA requires PM-KUSUM Component-B applicants to have installed, or to commit to installing, micro irrigation or an underground pipeline on the same land. Sequencing the two applications together saves a season.

How to check your application status

Haryana does not publish a single, dedicated online tracker for Per Drop More Crop applications the way some other DBT Haryana schemes do, so status checking is mostly a mix of the district office and the department's own records.

1. Keep your acknowledgement number safe. When you file the application at the district micro irrigation office, the receipt or acknowledgement issued at that point is the reference you will quote every time you follow up.
2. Ask the district micro irrigation office directly. Since the Department of Irrigation and Water Resources sanctions and verifies each case locally, the district office is the fastest source of truth on where your file stands: whether it is pending field verification, has received technical sanction, is awaiting installation, or is cleared for the post-installation inspection.
3. Call the farm-scheme helpline on 1800-180-2117 (Department of Agriculture and Farmers Welfare, Monday to Friday, 9:00 AM to 5:00 PM) if you cannot reach the district office or want a second point of contact. Quote your acknowledgement number, your name, and the village/block so the operator can direct the query correctly, since this helpline covers farm schemes generally and may need to route you back to the irrigation department for case-specific detail.
4. Watch for the field verification visit. A visible sign of progress is departmental staff coming to measure the area and check the water source; if this has not happened weeks after filing, that is worth raising at the district office rather than waiting further.
5. Confirm before installing. Do not treat silence as approval. If you have not received explicit technical sanction, do not let the supplier install the system, since installation before sanction is one of the documented reasons files get stuck or the cost is disallowed later.
6. After installation, track the post-installation inspection. The DBT payment is released only after this inspection confirms the system matches the sanctioned design, so a completed installation with no payment usually means the inspection is still pending, not that the claim was rejected.